|
|
Specifications |
|
API
Gravity 60/60 F |
28 |
|
Viscosity SUS @ 210 Deg.F |
86.98 |
|
Density |
7,2 lb/gal |
|
Solubility in Water |
Insoluble |
|
Melt
Point(oC) |
-17,8 |
|
Flash
Point(oC) |
315,5 |
|
Usual
Shipping Containers |
32 oz
(946 ml) Plastic Bottles |
|
The unique
chemistry of this proprietary formulation chemicaly bonds a
micro-thin Permafused Lubricant film to all lubricated
metalsurfaces inside an engine. Provides full time PfL
protection from friction, heat, wear, acid and corrosion,
unequaled by modern day motor oils, synthetic lubricants,
oil additives, moly or PTFE type engine treatments. Bishop´s
Original reacts only with PfL activated metal and does not
build-up, change tolerances or alter oil flow through
galleys and filters.
This unique
formula has proven over the past 28 years through official
testing and consumer use, to provide unequaled protection
and improved performance. The use of Bishop´s Original will
not void manufacturers engine waranty.
Karr V
Motortechnik , Hemmingen, Germany Test Results:
Vehicle: VW Golf
(1 500 cu.cm)
Power Improvement:
+3.2 HP
University of
Utah - Test Results:
Vehicle:Chevrolet
4 500 cu.cm.
Power Improvement:+15.6%
Fuel Milage:
+11.7 km per litter
Directions for use :
Change oil and
filter. Add 946 ml of Bishop´s Original 906 GDC HD Engine
Protection and top it off to manufacturer´s recommended
capacity. Start engine and run briefly to blend. Drive
normally until the next oil change. If less than 2500 km,
treat again as directed. DO NOT USE in new or rebuit engines
with less than 10 000 km or until ring have seated, Bishop´s
Original Engine Protection may be used regardless of the
accumulated miles on the engine.
Under normal
operating conditions, retreat every 100-150 000 kmEngines
subject to stop and go, severe or heavy duty use, we
recomment retreating at least once a year for optimum
protection and performance.
Additive
Package in this formula is compatible with oils meeting the
U.S.and EU waranty requirements: API, Caterpillar, Cumins,
Allison, Mack, MIL L 46152 C&D, MIL L 2104 E&D
Benefits :
Reduces: Friction,
Heat, Wear, Oil Consumption, APM Draw, Idle Overheating and
Corrosion
Improves:
Compression, Horsepower, Fuel Millage, Engine Life, Cold
Weather Starts, and Overall Performance.
Also Provides
Protection From: Oil Shear, Oil Loss, Additive Breakdown,
Acids and Dry Starts.
|
